PHILIPS SRU520/87
Manual de Usuario

SRU520_87_v6.qxd

26-04-2005

14:38

Pagina 5

Instructions for use 3
� Check whether all the keys are working. For an overview of the keys and their functions see �3. Keys and functions�. If the TV responds as it should to all of the key commands the SRU520 is ready for use. If the device does not respond at all or not to all of the key commands, follow the instructions under �Setting the remote control�, or for online setup go to: www.philips.com/urc.

�

Setting the remote control
This is only necessary if your device does not respond to the SRU520. If that is the case, the SRU520 does not recognize the brand and/or model of your device and you need to program the remote control to do so. The example below (TV) instructs you how to do this.You can repeat the same steps for other devices (VCR/DVD players/recorders) which you want to operate using the SRU520. You can set the remote control either automatically or manually. Automatically setting the remote control The remote control will now automatically search for the right code for your device. Example of TV: 1 Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). The SRU520 emits the �switch off TV� signal for all models of TV that are stored in the memory. � If the device is a DVD-player or video recorder, insert a disk or tape and start playback. 2 Press the TV key to select TV. Press the key until it lights up.

3

Then keep keys 1 and 3 on the SRU520 pressed simultaneously for three seconds, until the key flashes twice and then remains lit.

4

Press and hold the Standby key of the SRU520.

�

The SRU520 now starts emitting all known �TV off � signals, one by one. Each time a code is sent, the TV key lights up.

5

English