|
Usuarios conectados
Actualmente hay 5683 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
SRS-D313 SECTION 1 GENERAL
This section is extracted from instruction manual.
A
Attach the reflectors (no distinction between right and left) to the speakers as shown Fixez les réflecteurs (pas de distinction entre le réflecteur gauche et le droit) sur les enceintes comme indiqué ci-dessous. Bringen Sie die Reflektoren (kein Unterschied zwischen rechts und links) wie abgebildet an den Lautsprechern an. Conecte los reflectores (no hay distinción entre derecho e izquierdo) a los altavoces, tal como se muestra .
Hooking up the system
1 Attach the reflector to the speakers. (See fig. A.) 2 (See fig. B for steps 2 through 4.)
Connect the left speaker cord 8 pin plug to the rear panel jack with their respective arrows aligned.
3 4 5
Connect the subwoofer to the wall outlet. Connect the CD walkman, PC, etc., to the INPUT jack on the left speaker. Position the speakers. (See fig. C.)
B
Front (Right)/Avant (droite) Vorne (rechts)/Parte frontal (derecha)
Front (Left)/Avant (gauche) Vorne (links)/Parte frontal (izquierda)
Listening to the sound
(see fig. D)
First, turn down the volume on the left speaker. The volume should be set to minimum before you begin playing the programme source.
Subwoofer Caisson de grave Tiefsttonlautsprecher Potenciación de graves
PC/Ordinateur PC/PC
1
Press POWER on the left speaker.
The POWER indicator lights up green. For the European models Press POWER on the subwoofer to turn it on, and then press OPERATE on the left speaker. The OPERATE indicator lights up green. The main power source of the system is provided by the subwoofer. When the power of the subwoofer is turned off, the system does not operate, even if OPERATE is pressed.
CD Walkman Walkman CD CD-Walkman CD Walkman to 8 pin Din jack vers la prise Din à 8 broches an 8 polige DIN-Buchse a conector DIN de 8 patillas to wall outlet vers la prise murale an eine Netzsteckdose a la toma de corriente Front (Right)/Avant (droite) Vorne (rechts)/Parte frontal (derecha)
to Mono Mini Jack vers la mini prise mono an Mono-Ministecker a minienchufe mono
2 3
Rotate INPUT to select 1/2.
You can enjoy the mixed sound from INPUT 1 and 2.
C
Front (Left)/Avant (gauche) Vorne (links)/Parte frontal (izquierda) Note PC PC Note Notebook-PC Portátil
To adjust the volume
Rotate VOLUME.
Play the programme source.
To adjust the subwoofer
Rotate BASS to adjust the bass volume. Set the volume level to best suit your preference according to the programme source.
Using the headphones/earphones
* This switch is only for European models. Cet interrupteur ne concerne que les modèles européens. Dieser Schalter ist nur für Modelle für Europa. Este interruptor sólo está destinado a los modelos europeos.
Subwoofer Caisson de grave Tiefsttonlautsprecher Potenciación de graves
Connect the headphones/earphones to the PHONES jack. Notes � To enjoy high-quality sound, do not turn the BASS volume too high. � When using the headphones, you cannot adjust the bass volume.
*
Troubleshooting
Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer.
D
POWER
ON OFF
There is no sound from the speaker system.
POWER (OPERATE for European model) (OPERATE pour le modèle européen) (OPERATE beim Modell für Europa) (OPERATE para el modelo europeo) VOLUME
MIN MAX
� Make sure all the connections have been correctly made. � Make sure the volume on the left speaker and the connected component have been turned up properly. � Check if headphones are connected. If they are, disconnect them.
VOLUME
There is distortion in the subwoofer sound output.
� Turn down the volume level on the connected component. Or, if the connected component has the bass boost function, set it to off. � Rotate BASS on this unit to reduce the bass volume.
BASS
BASS
MIN MAX
There is hum or noise in the speaker output.
INPUT
INPUT
1
2
PHONES
PHONES
L
� Make sure all the connections have been correctly made. � Make sure none of the audio components are positioned too close to the TV set.
The sound has suddenly stopped.
Make sure all the connections have been correctly made.
3
|
|
|
> |
|