PIONEER S-RS3SW/LFXJ
Manual de Servicio

1

2

3

4

2.2 PANEL FACILITIES
FRONT PANEL
A

4 Crossover knob (CROSSOVER)
1
POWER ON

When using the subwoofer, set the upper frequency limit for the subwoofer (50 Hz to 200 Hz) so that it complements the output from your other speakers. When using the bass management features of an AV receiver, set to BYPASS ON in order to use the low-pass filter of the AV receiver for high quality sound.

5 Bypass switch (BYPASS)
When set to ON, the audio signal is routed directly to the woofer unit, bypassing the amplifier�s filter.
B

6 Phase switch (PHASE 0º /180º)
When set to 180º, the output phase becomes the reverse of the input signal, and when set to 0º, it is in the same phase as the input signal. � Normally, the switch is set to 0º. But when the sound connection between the subwoofer and the left and right speakers sounds unnatural, try switching to 180º and set the switch in the position where the sound is natural. � When using two or more subwoofers together, make sure that the phase switch of all of them are set to the same position.

1 Power Indicator (POWER ON)
Lights green when the power has been switched ON.

NOTE:
C

� If you are planning on switching the unit OFF for a long period of time, make sure to check that the indicator light has gone out after switching OFF.

7 Line Level Input terminal (LINE LEVEL INPUT)
Connect to the SUBWOOFER PREOUT terminal of an amplifier or receiver, with a RCA plug cord.

REAR PANEL

8 Line Level Output terminal (LINE LEVEL OUTPUT)
Used for connecting other equipment through the amplifier. The signal output from this jack is not affected in any way by the settings of the various controls on the unit.

D

9 AC IN
POWER VOLUME CROSSOVER

MAX MIN 200 Hz 50 Hz

2 3 4 5 6

� Connect the power cord to the powered subwoofer unit�s AC IN. � Connect the power cord to a AC socket.

BYPASS

ON OFF

PHASE

LINE LEVEL

OUTPUT INPUT AC IN

7 8 9

E

2 Power switch (POWER)
Switches the subwoofer between ON and OFF.

3 Volume knob (VOLUME)
Sets the subwoofer volume. � Turn the knob slowly from the MIN position. � With this unit, the bass level can be independently set, so do not turn up the bass on the AV amplifier.
F

6
1 2

S-RS3SW
3 4