|
No hay comentarios de productos.
4.
TEST MODE
BASE UNIT
[Setting the Test Mode] 1. Power on with pressing the [HANDSET LOCATOR] key for two seconds. 2. CHARGE and LINE LEDs turn on for 50 msec, and the test mode is set. * If setting the test mode with the status that [TONE] position is selected at [DIAL MODE] switch, the unit cold stars next time when the power is turned on. [Releasing the Test Mode] To release the test mode, perform as follows: � Turn the power off (disconnect the AC adapter plug). � Set the handset to charge on the base unit (except Test Mode 9). � Bell in. [Changing the Test Mode Step] 1. Set the [DIAL MODE] switch to the [PULSE] position. 2. Press the [HANDSET LOCATOR] key. 3. A step is changed each time the key is pressed, and CHARGE and LINE LEDs turn on for 50 msec. [Changing the Channel] 1. Set the [DIAL MODE] switch to the [TONE] position. 2. Press the [HANDSET LOCATOR] key. 3. A channel is changed each time the key is pressed, and CHARGE and LINE LEDs turn on for 50 msec. * Channel will be back to initial channel (19CH), when the test mode step is changed. � Channel Rotation
19CH
20CH
21CH
40CH
1CH
2CH
3CH
...
39CH
40CH
�5�
|
