TELEX SPINWISE4-40HN
Manual de Usuario

Emulate
The �Emulate� function performs the same operation as �Copy� except that the data is not actually written onto the CD-R media. CD-R discs will remain blank when the Emulation operation is performed. This operation is used to confirm the status of the target Master Disc. It is also used to test the system during setup or after being transported.

Compare
The �Compare� function performs comparison between master and target discs. (Data CD�s only).

Verify
The �Verify� function performs Verification of Audio or Video data written to blank CD R media from a target or master disc. Different discs in the CD writer and CD reader can be verified together simultaneously.

Sub Functions:
The Sub Functions provided in the Spinwise System are designed to allow the user to alter and enhance the performance of the system according to their needs and applications. In the main menu, press and hold down the �Status� button for five seconds. The menu will be switched to the Sub-Function menu. To return to the main menu, press and hold down the �Status� button for five seconds.

Setup
As there are different settings under the Setup Sub Function to control the Spinwise System, we suggest using the original default settings for optimal operation be used. Changes should be made only when you are very familiar with it�s operation.

Start Writers
This setting controls the number of CD writers that will work in the Spinwise 440/740. Normally it should be equal to the number of writers installed in the Spinwise 440/740. However, the number of writers set to record can actually be less than the number installed. If seven writers are installed, for example, number setting of 2 will allow using only two writers at one time. Spinwise 440/740 will start the operation instantly when any two of the seven installed writers are ready (disc detected). The other five writers will be idle. Press the �Status� button to change the setting and press the �Start� button to exit.

Write Method
This setting controls the writing methods of the CD R media including �Disc at Once� or �Track at Once�. �Disc at Once� is the default setting. Press the �Status� button to change the setting and the �Start� button to exit.

Write Speed
This setting controls the maximum writing speed of the CD writers. The default setting is �MAX� which will use the highest writing speed of the writers (16X). For applications requiring a lower write speed, use this setting to adjust to 24X, 16X, 12X, 8X, 4X, or 2X. Press the �Status� button to change the setting and the �Start� button to exit.

3