Operations
Turning On the Power�POWER �
Front view
Press the ON [ � ] portion of the POWER switch. The main power turns on and the power lamp in the front panel lights in green. � The power lamp lights in red when the Auto Power On/ Standby places the unit into standby mode (see page 7).
Power lamp
To completely cut off the power to this unit Press the OFF [ � ] portion of the POWER switch. This will disconnect the mains lead.
Rear view
Adjusting the Volume�VOLUME ı
Adjust the volume output level through this unit while comparing with the sounds coming out of the main (front) speakers. � Once you have adjusted the volume output level of this unit, you do not need to adjust it each time you use this unit. Adjusting the volume level on the connected amplifier will also adjust the volume level through this unit.
1 Turn the VOLUME knob to the MIN position.
VOLUME
MIN
MAX
VOLUME
FREQUENCY
ı
VOLUME
MAX
MIN
50Hz
200Hz PHASE CUT OFF FILTER
REVERSE NORMAL FIXED VARIABLE
�
FREQUENCY
2 Turn on the connected amplifier and start playing a
source. Playback sounds come out of the main (front) speakers and this unit.
�
PHASE
AUTO POWER ON/STANDBY
RIGHT LEFT/MONO
�
INPUT 1 (LOW-LEVEL)
�
AUTO POWER ON/STANDBY
ON CANCEL
CUT OFF FILTER
RIGHT
LEFT
3 Adjust the VOLUME knob to obtain a well-balanced sound
level with that of the main (front) speakers.
VOLUME
INPUT 2 (HIGH-LEVEL)
TO MAIN SPEAKERS
RIGHT LEFT
MIN
�
POWER
MAX
OFF ON
POWER
If the volume is set at a high level before starting play, the sudden blast of sound energy can permanently damage your hearing and/or ruin your speakers.
