SONY SNT-V304
Manual de Servicio

1-14 (E) SNT-V304
Operation Camera View Operations
The Camera View displays the video camera images. Use the screen buttons and icons to switch between cameras and display modes. 8 [PRESET] Drop-Down List Select a preset camera position by name from this list to set the camera to that fixed position (previously set by the system administrator). 9 [HSR] Button Clicking this button changes to the HSR view, in which images of video cameras connected to an HSR1/1P/2/2P can be monitored, and the HSR-1/1P/2/2P can be controlled. Refer to the �HSR View Mode� on page 33 for details. qd 2 3 4 5 qf 6 7 8 9 0 0 [Admin] Button Clicking this button displays the �Administration overview� page, where video network station settings and management can be performed. Access to this page is normally restricted to the system administrator. qa Site Name This is the name assigned to the overall video network station system. qs Camera Title This is the title of the video camera. qd Date and Time This is current date and time. qf Video Camera Images Clicking at a point in an image causes the video camera to pan and tilt so that the clicked point becomes the center of the image. qa qs 1 1 [ALL] Button Clicking this button switches the monitor screen to the ALL mode (as shown in the above example). In this mode, images from the video cameras connected to the video network station are displayed in two or four partitions. 2 [CAM1] to [CAM4] Buttons Clicking one of these buttons changes the monitor screen to the Single mode, in which only one video camera image is displayed. Each button corresponds to one of the video input terminals (�VIDEO 1� to �VIDEO 4�) on the video network station. Buttons corresponding to disabled video input terminals are not displayed. 3 [SEQ] Button Clicking this button changes the monitor screen to the Sequential mode, in which the image from each video camera is displayed one at a time, switching from one camera to the next at preset intervals. 4 [ALARM] Button Clicking this button changes the monitor screen to the Alarm mode, which allows searching images or replaying video when an alarm has occurred. Refer to �Viewing Alarm Event Images� on page 29 for details. 5 [ALARM MEMORY] Indicator Images acquired when alarm events occur are stored in the memory of the video network station. The amount of available memory is indicated in seven steps from �E� (empty) to �F� (full). 6 Users Logged On Shows the number of users logged on to the video network station. The value for the number of users logged on is only an approximation. 7 [HOME] Button Returns the video camera to the home position.

26

27