g Instrucions for use
Safety instructions
Before first use, it is imperative to read through the Instructions for Use carefully! The operating voltage and mains voltage must agree! (See rating plate on base of juice extractor.) Only operate the appliance under supervision! Even if you leave the room only very briefly, switch off and unplug the appliance. Keep children well away! Never place your hand in the filling shaft when the appliance is running. When replenishing, always use the plunger. Never insert any long objects, such as kitchen knives, food slices, etc., in the filling shaft. Before maintenance or cleaning, make sure that the appliance is switched off and unplugged. Please wait until the motor has stopped before removing the upper part of the housing. Never use the supply lead to pull the plug out of the socket! Never immerse the appliance in water! Never use the appliance if: � the supply lead is damaged; � the housing shows visible damage. Repairs to electrical appliances should only be performed by a trained electrician. Improper repairs may place the user at serious risk. In the event of a fault, please approach your specialist retailer or the Electrolux Service Centre direct. Should the appliance be wrongly used or for a purpose other than for which it is intended, no liability can be accepted for any possible damage.
; This appliance complies with the following EC Directives: � 73/23/EEC of 19.02.1973 � LowVoltage Directive. � 89/336/EEC of 03.05.1989 (including Amendment Directive 92/31/EEC) � EMC (Electromagnetic Compatibility) Directive.
Technical data
Connected load: 200 W. Continuous operation, protectively insulated, radio interference suppressed.
Assembling the juice extractor
Before first use, the appliance parts should be cleaned (section on �Dismantling and cleaning�). 1.Arrange the motor part in an upright position so that the knob at the front faces you. 2.Place the juice bowl with the juice outlet on the LH side of the motor part (Fig. 2). 3.Place the strainer basket in the juice bowl (Fig. 3). 4.Place the upper part with the juice outlet on the LH side (Fig. 4). Engage and press down the locking clips (Fig. 5). 5.Insert the residue container (Fig.6 ) 6.Flex compartment: unwanted flex can be inserted in the flex compartment. 7.Place a suitable container under the juice outlet (Fig. 7). 8.Position the plunger. Place the appliance on a smooth, dry working surface. The appliance can only be switched on if the locking clips are properly closed.
