PIONEER S-IW531L/XTM/UC
Manual de Servicio

1

2

3

4

1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
A

� The grille is inserted into the baf�e. To detach it, insert the grill removal tool into each of the 4 corner holes of the grille net and pull it out carefully. � The baffle frame is attached to the wall/ceiling by 6 external screws. To detach it, unfasten those screws. � The crossover networks is attached to the baf�e by 4 external screws. To detach them, first disconnect the speaker's wires. Next remove the baf�e. Then unfasten those screws. � The tweeter is attached to the baf�e by 2 external screws. To detach it, unfasten those screws. When re-attaching it, face its terminal rightward. � The woofers are attached to the baf�e by 4 external screws. To detach them, unfasten those screws. When re-attaching them, face its terminal lower right. � Attach the speaker frame to the wall/ceiling, and tighten the screws lightly (temporary attachment). At this point the rotating clamp will rotate so that the rotating clamp and frame are clamped on to the wall/ceiling. Gently try pulling the speaker forward and check that all of the rotating clamps have rotated outwards and are lightly clamping to the wall/ceiling.

B

C

Rotating clamp Speaker frame

D

Screw

� Tighten the screws firmly using no more than the maximum torque speci�ed. Allowable maximum torque: 1.0 N.m � Screwing them in too tightly could break the rotating clamps, twist the frames, damage the walls/ceilings and make it dif�cult to attach the grille.

E

F

2
1 2

S-IW531L
3 4