Step 2 : Detach the flat wire from the ribs of rear cabinet. (Ensure during assembly, the flat wire must be properly dressed in between the 2 supporting ribs.) Step 3 : Detach connector CN1003. Step 4 : Remove Receiver Module P.C.B. as arrow shown. Caution : Avoid applying excessive force. Use anti-static strap when removing the Receiver Module P.C.B. Step 1 : Remove Heat Sink Clip as arrow shown.
7.7.
Disassembly of Digital Amp P.C.B.
· Follow the (Step 1) - (Step 3) of item 7.4. · Follow the (Step 1) - (Step 2) of item 7.6.
Step 2 : De-solder digital Amp IC and remove Insulator IC. Note: During assembly, after replacement of new digital Amp IC installation of insulator needed.
7.9.
Disassembly of SMPS Module Unit
· Follow the (Step 1) - (Step 3) of item 7.4. Step 1 : Detach flat cabl (CN2). Step 2 : Remove Digital Amp P.C.B. as arrow shown. · Follow the (Step 1) - (Step 2) of item 7.6.
7.8.
Disassembly of Digital Amp IC
· Follow the (Step 1) - (Step 3) of item 7.4. · Follow the (Step 1) - (Step 2) of item 7.6. · Follow the (Step 1) - (Step 2) of item 7.7.
