PIONEER S-FCRW861-S/KUXJI
Manual de Usuario

www.pioneerelectronics.com

OPERATING YOUR SYSTEM
Turn on your receiver with the level control initially at zero.

CABINET MAINTENANCE
Use a polishing cloth or dry cloth to wipe off dust and dirt. When the cabinet is very dirty, clean with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and then wipe again with a dry cloth. Do not use furniture wax or cleaners. Never use thinners, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces.

IMPORTANT:
Follow the instructions for your receiver and set the speakers to SMALL in the 5.1 mode (Dolby Digital). This will ensure that any bass signals are re-directed to the subwoofer where they will be optimally reproduced. If you have a choice, set the crossover frequency to 150Hz.

Now gradually increase the volume until you reach a comfortable listening level.

WARNING:
UNPLUG THE POWERE D SUBWOOFER BEFORE CLEANING TO REDUCE THE RISK OF ELECTRIC SHOCK

CAUTION:
The speakers are equipped with a protection device to protect the transducers from extreme conditions. Under these conditions the protection device will activate and stop the speaker from producing sound. If this happens shut off the system for 5-10 minutes and allow the protection device to reset.

NON SKID PADS
If the front, center and rear speakers are placed on a hard surface, such as wood or tile place four non skid pads on the bottom surface of the speakers.

SUBWOOFER REAR SECTION

13

2

LINE LEVEL IN POWER INDICATOR

VOLUME LEVEL

MIN

MAX

If the subwoofer is placed on a hard floor, such as wood or tile, place four non skid pads on the bottom surface of the subwoofer.

Illuminates RED when the power is being supplied.

1 POWER INDICATOR 2 VOLUME LEVEL

Volume of subwoofer is adjusted with this knob. Turn this knob clockwise to raise the level. � Starting with �MIN�, turn this knob and raise the volume slowly. If the unit is turned on with the volume set too high, it could cause hearing and/or speaker damage. Do not turn the volume up excessively high. The low frequency sound is apt to be raised too high since it is less disturbing and harder to detect than high frequencies. Caution must be taken here since the amplifier and speaker will be clipped when the output of the amplifier or receiver is increased with the subwoofer level set to �MAX�.

Connect SUBWOOFER OUTPUT terminal of the receiver to this terminal with the supplied RCA cable.

3 LINE LEVEL IN

5