PIONEER S-FCRW2700/XJC/E
Manual de Usuario

CONNECTING YOUR SYSTEM

PLACEMENT AND FINE TUNING
SUBWOOFER
Sound spreads in all directions in the very low frequency range. Human hearing cannot easily detect the source of very low frequencies. Be sure to provide a space of at least 8 inches (20cm) between the rear of the subwoofer and the nearest wall.

IMPORTANT:
Make sure all equipment is turned off before making any connections.

FRONT / CENTER / SURROUND / SUBWOOFER SPEAKERS
Correct wiring of your loudspeakers is essential for achieving the best sound quality. Be careful to ensure proper polarity of connection.

FRONT SPEAKERS
For best results the loudspeaker should be positioned near ear level and the loudspeakers separated a distance approximately equal to the listening distance. Angling the loudspeakers inward towards the listener will improve the image stability for non-central listeners. Close proximity to a side or rear wall will enhance the midbass performance, although too close (particularly a corner location) and the bass may be unnaturally high and image performance may be degraded.

Twist and pull off the protective shields on each wire.

CENTER SPEAKER
The loudspeaker should be positioned below the TV. For best results align the front of the loudspeaker with the front of the TV. If the loudspeaker is placed under the TV and very close to the floor, then tilting upwards may be beneficial.

Connect to the speaker terminals on the rear of the receiver.
To connect, insert the colored wire into the matching positive (colored) terminal and the other wire into the negative (black) terminal as shown below. Note that the color-coded tabs are as follows: � Red : Front right (R) � White : Front left (L) � Green : Center speaker � Purple : Subwoofer � Grey : Surround right (R) � Blue : Surround left (L)

SURROUND SPEAKERS
For best results the loudspeakers should be positioned at or above ear level. Depending upon your room layout and preferences, the left and right rear speakers should be positioned on the side walls just the rear of the listening position, or on the walls.

CENTER SPEAKER ONLY
Connect the speaker cords to the input terminals at the rear of center speaker. Match the colored wire with the color-coded label (above the tabs), then insert the colored wire into the red (+) tab and the other wire with the black (�) tab. red (+) black (�) Green Colored marker

2