Place the new document stopper enclosed in the position from which the old document stopper was removed. Keep it pressed firmly against the document glass while securing it using the front and rear stopper mounting screws enclosed. Make sure that the tabs under the document stopper fit into the notches on the copier.
Tabs New document stopper Front stopper mounting screw Rear stopper mounting screw
Positioning the holes in the hinges of the ADF over the ADF mounting screws, secure the ADF with the 2 ADF securing screws.
ADF securing screw
ADF mounting screw
Notches
ADF securing screw
3. Mount the ADF onto the copier.
Remove the 2 cut-outs from the upper cabinet panel of the copier.
Cut-outs Upper rear cabinet panel
4. Adjust the angle of the ADF.
Loosen the 2 screws that secure the angle adjusting panel which fixes the hinge angle, then raise the angle adjusting panel completely and tighten the loosened screws.
5. Connect the ADF connector.
Remove the connector cover from the rear cabinet panel of the copier. Plug the ADF connector into the connector on the copier.
