You can now adjust the dial mode or press to return to standby.
Note The use of your SE140 cannot be guaranteed on all PABX.
1
6.4 Dial mode The default SE140 dialling mode is suitable for your country and network. It is unlikely that you should need to change this setting. 1 Press four times. The display shows -1- or
-2-.
2
2
3 4
3 4
Press or to switch between 1 = Tone and 2 = Pulse. Press to save the settings. You can now adjust the recall mode, see below, or press to return to standby.
Press �ve times. The display shows FLASH and the current setting Press or to switch between 1 (Flash 1 with Time break recall, or 2 (Flash 2 with Time break recall). Press to save the settings. You can now adjust Autopre�x or press to return to standby.
6.5 Recall mode The button is used with certain network services and PABX*/switchboard services. You will not normally need to change this setting unless advised to do so.
6.6 Auto-pre�x You can set the SE140 to detect a dialling number and replace it with another number. The total of both numbers together can be up to a maximum of 24 digits. 1 Press six times. The display shows (-----------). 2 In the �rst set of spaces, enter the number you want to be detected (max. 4 digits). Press or to move the cursor.
