SONY SDMN50PS
Manual de Servicio

Installing the display vertically
This display can be installed either horizontally or vertically using the supplied display stand.

While sliding the stopper up, close the display stand.

To close the display stand

Selecting the on-screen menu language (LANGUAGE)
English, German, French, Spanish, Italian, and Japanese versions of the on-screen menus are available. The default setting is English.

Selecting the input signal
You can connect two computers to this monitor using the INPUT 1 and INPUT 2 connectors. To select one of the two computers, use the INPUT button. Press the INPUT button. The input signal and corresponding input indicator, �1� (INPUT 1) or �2� (INPUT 2) change each time you press this button.

To switch to the horizontal or vertical viewing position
First install the supplied WinPortrait (for Windws 95/98 and NT4.0) or MacPortrait (for Macintosh). To switch the view, press Shift + Ctrl + R on the keyboard. For more information, see the supplied software�s instruction manual.

1 Press the MENU button.
The stopper MENU
PHA S E

INPUT
16

To install the display horizontally or vertically
Open the display stand until the click sound is heard. Put the display on the stand, aligning the mark which shows the stand position on the display.

,

1 2 OK

Using the headphones
Horizontal installation You can listen to the audio signals from your computer or other audio equipment using headphones. Connect the AUDIO IN jack to the audio output jack of your computer or other audio equipment using the supplied audio cord.

EX I T

2 Press the M(+)/m(�) buttons to select m.
B A S S BOOS T ON OF F

,
Adjusting the volume 1 Press the 2 +/� buttons.
The VOLUME menu appears on the screen.
VOL UME

Notes � You cannot select the input signal when displaying the main menu on the screen. � If no signal is input to the selected connector, NO INPUT SIGNAL or CABLE DISCONNECTED appears on the screen. After a few seconds, the monitor enters the power saving mode. If this happens, select the other connector using the INPUT button.

EX I T

GB

3 Press the M(+)/m(�) buttons to select
(LANGUAGE) and press the OK button.
40
L A NGU AGE

The stand positioning mark

,

Vertical installation

INPUT

,
2 Press the 2 +/� button to adjust the volume.

1 2 OK

,

ENG L I SH DEU T SCH FRAN�A I S ESPA�OL I TAL I ANO

1-4
The menu automatically disappears after about 3 seconds.
Notes � You cannot adjust the volume when displaying the main menu on the screen. � When your monitor is in power saving mode, no sound comes from the headphones.

EX I T

4 Press the M(+)/m(�) button to select a language.
� ENGLISH � � � � � DEUTSCH: German FRAN�AIS: French ESPA�OL: Spanish ITALIANO: Italian : Japanese

The stand positioning mark

To close the menu Press the MENU button once to return to normal viewing. If no buttons are pressed, the menu closes automatically after about 30 seconds.

10

11