|
Usuarios conectados
Actualmente hay 6040 visitantes y 3 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
ORDER NO.
S-CR02
RRV2852
SPEAKER SYSTEM
S-CR02
65S This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely repair complex products such as those covered by this manual. Improperly performed repairs can adversely affect the safety and reliability of the product and may void the warranty. If you are not qualified to perform the repair of this product properly and safely, you should not risk trying to do so and refer the repair to a qualified service technician. WARNING
XJI/CN
This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to cause cancer, birth defects or other reproductive harm. Health & Safety Code Section 25249.6 � Proposition 65
FOR PRECAUTION OF REASSEMBLY AND DISASSEMBLY
( Center Speaker ) The loudspeaker is attached to the cabinet by 6 external screws. To detach it, unfasten those screws. When replacing the loudspeaker, make sure it is positioned so that the wire terminals are oriented at the opposite side from the Pioneer logo on the grill, then secure it with the 6 screws provided. Make sure the adhesive padding on the cabinet stays in place and is not peeling off. If necessary, replace the padding. Make sure the speaker wire from the cabinet is connected to the loudspeaker terminals. If necessary, arrange the acoustic insulation so that the loudspeaker fits the cabinet. Connect the grill to the front of the cabinet, making sure that the wires are kept out of the way. Secure the cabinet from the rear side with the 6 screws provided. ( Rear Speaker ) The loudspeaker is attached to the cabinet by 4 external screws. To detach it, unfasten those screws. When replacing the loudspeaker, make sure it is positioned so that the wire terminals are oriented at the opposite side from the Pioneer logo on the grill, then secure it with the 4 screws provided. Make sure the adhesive padding on the cabinet stays in place and is not peeling off. If necessary, replace the padding. Make sure the speaker wire from the cabinet is connected to the loudspeaker terminals. If necessary, arrange the acoustic insulation so that the loudspeaker fits the cabinet. Connect the grill to the front of the cabinet. Secure the cabinet from the rear side with the 4 screws provided.
4-1, Meguro 1-chome, Meguro-ku, Tokyo 153-8654, Japan PIONEER ELECTRONICS (USA) INC. P.O. Box 1760, Long Beach, CA 90801-1760, U.S.A. PIONEER EUROPE NV Haven 1087, Keetberglaan 1, 9120 Melsele, Belgium PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936
PIONEER CORPORATION
PIONEER CORPORATION 2003
T � ZZP OCT. 2003 Printed in Japan
|
|
|
> |
|