PHILIPS SBCSC469/05
Manual de Usuario

14

ENGLISH

5 If you wish to store another telephone number press the M(emory)
button (1) again to select a memory location and repeat steps 3 and 4. Notes: � With the C(lear) button on the keypad (5) you can always clear the last entered digit. � When no key is pressed for 5 seconds the Baby Unit leaves the programming mode. � In case your telephone network requires a short pause between numbers (e.g. for selecting an outside line), a pause can be stored by pressing the button on the keypad (5). The display will next show a �P�.

Clearing telephone numbers

1 Press the PRG (Program) button on the keypad (5).
> �M1� blinks on the display.

2 Press the M(emory) button (1).
> �M1� lights up on the display together with the telephone number.

3 Press the �0� button on the keypad (5). 4 Briefly press the C(lear) button on the keypad (5).
> The icon starts flashing and the number disappears from the display. The number has now been cleared and the memory location is available again.

5 Repeat steps 2, 3 and 4 to clear other telephone numbers.
Note:To clear all numbers,you can also reset the unit. All user settings will be reset to the factory default. See �Resetting the Baby Unit� for more information.

Storing your PIN code
When using the Baby monitor in Dial-up mode, use of the PIN code is necessary. It prevents others from listening to your baby.The PIN code has to be entered when placing calls to the Baby Unit

1 Press the PRG (Program) button on the keypad (5). 2 Press the PIN button on the keypad (5). 3 4
> �PIN� and �� � � �� start flashing on the display. Use the numeric keypad (5) to enter the required PIN code.The code must consist of 4 digits. If the code is correct, press the OK button on the keypad (5) to store the code in the memory.