PHILIPS SBCRU510/87U
Manual de Usuario

RU530_87.qxd 04-06-2004 16:57 Pagina 5

Instructions for use Setting the remote control
This is only necessary if your appliance does not respond to the RU530. If that is the case, the RU530 does not recognize the brand and/or model of your appliance and you need to program the remote control to do so. The example below (TV) instructs you how to do this. You can repeat the same steps for other appliances (VCR, satellite or cable decoder) which you want to operate using the RU530. Example of TV: 1 Turn on the TV manually or use the original remote control. Tune in to channel 1. 2 Look up the brand of your TV in the code list at the back of this manual. One or more four-figure codes are shown for each brand. Note the first code. Be careful! There are separate tables for TV,VCR and SAT. Make sure you use the codes from the correct table. 3 Select TV with the mode selector. (See �Testing the remote control�.)
TV VCR SAT

4

Keep keys �1� and �3� pressed simultaneously for three seconds until the green light under TV in the selector window flashes twice and then remains lit.

ME

NU

OK

1 4 7

2 5 8 0

3 6 9

5
�

6
�

Then enter the code noted in step 2 using the digital keys. The green light in the selector window will now flash twice. If the light flashes once for an extended period, the code has not been entered properly or the wrong code has been entered. Start again from step 2. Point the RU530 at the TV and check that it responds as it should. If the TV responds to all of the key commands, the RU530 is ready for use. Do not forget to note your code. If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list.

SHIFT

�

5

English