2-13. TRAY (SUB)
1 Turn the pulley (LD) and move the slider (selection) in the direction of the arrow L. 2 Turn the pulley (mode) in the direction of the arrow to adjust the tray (sub) that you want to remove. (It depends on the height and position of the stocker.) 3 Turn the pulley (LD) and move the slider (selection) in the direction of the arrow R. 4 Turn the pulley (mode) in the direction of the arrow so that you can remove the tray (sub) that you want to remove.
Pully (LD)
Slider (selection)
Stocker section
L R
Pully (mode)
Tray (sub)
2-14. CHASSIS (MOLD B), STOCKER, SLIDER (SELECTION)
Note: When assembling the parts, refer to pages 13 and 14.
7 Two screws (PTPWH M2.6) 6 Stocker section 8 Slider (selection) 9 Washer
0 Compression spring
Pully (LD)
1 Three screws (BVTP M2.6)
5 Two step screws
2 Chassis (mold B) section
Note: Rotating the pully (LD), shift the slider (selection) to the left.
