Inicio >>
AEG >>
SANTOSUPER2580-6SILV Manual de Usuario
0 artículo(s) en Su carrito
Opiniones de los clientes
No hay comentarios de productos.
TEXT_PDF_SNIPPET
Symptom
Possible Cause
Temperature is not properly adjusted. Door was open for an extended period.
Remedy
Please look in the "Initial Start Up" section. Open the door only as long as necessary. tor to a colder setting.
1. 2.
The food is too warm.
A large quantity of warm food Turn the temperature regulawas placed in the appliance within the last 24 hours. The appliance is near a heat source.
However when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: Remove the frozen food from the freezer, wrap it in several layers of newspaper and put it in a very cool place. Switch off the appliance and pull out the plug or turn the temperature selector to �0� OFF. Leave the freezer compartment door open. Leave the door open, and place a basin on the top shelf of the refrigerator compartment, under the drain hole, lift the
3. 4.
Please look in the "Installation location" section. Please look in the "Changing the Light Bulb" section.
Interior lighting does not work. Light bulb is defective.
Door seal is not air tight (pos- Carefully warm the leaking sibly after reversing the door). sections of the door seal with a hair dryer (not hotter than Heavy build up of frost, possiapprox. 50 °C). At the same bly also on the door seal. time shape the warmed door seal by hand such that it sits correctly. Appliance is not level. Unusual noises. Readjust the feet.
5.
plug as shown in the figure. Turn the thermostat knob to the required setting and replace the plug in the power socket. Warning!
PR116
Never use metal tools to scrape off the frost Do not use a mechanical device or any artificial means to speed up the thawing process. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life.
The appliance is touching the Move the appliance slightly. wall or other objects. This is normal, no error has occurred. The compressor starts after a period of time.
The compressor does not start immediately after changing the temperature setting.
Water on the floor or on stora- Water drain hole is blocked. ge shelves.
See the "Cleaning and Care" section.
Switching off the appliance
To switch off the appliance, turn the temperature regulator to position "0" or disconnect from the electricity supply. If the appliance is not going to be used for an extended period: 1. 2. 3. 4. Remove all refrigerated and deep-frozen packages as well as ice trays. Remove the mains plug or switch off. Defrost freezer compartment and clean thoroughly (see section: �Cleaning and Care�). Leave the door open to avoid the build up of odours.
If after all these checks your appliance does not operate correctly, contact your local AEG Service Force Centre. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.