PANASONIC SAHT680
Manual de Usuario

Other useful functions
SHIFT
TEST CH SELECT

Speaker level adjustments

SHIFT

SLEEP QUICK OSD

Sleep timer

This is one of the ways to get appropriate surround effects. Preparation Press [DVD/CD].

Press [SHIFT]i[SLEEP] to select the time (in minutes).
SLEEP 30_----)SLEEP 60_----)SLEEP 90 ^""""" OFF(_ SLEEP 120(__}
SLEEP

1

While stopped and no on-screen display is shown

Press [SHIFT]i[TEST] to output a test signal.
L: Front left C: Center R: Front right RS: Right surround LS: Left surround �There is no output from SW (subwoofer) channel. To cancel the timer Press [SHIFT]i[SLEEP] to select �OFF�. To confirm the remaining time Press [SHIFT]i[SLEEP] again. To change the setting Repeat the procedure from the beginning.

2 3

Press [VOLUME, r] or [s] to set the volume level normally used for listening. Press [3] (increase) or [4] (decrease) to adjust the speaker level for each speaker.
C, RS, LS: `6 dB to i6 dB (L, R: Only the balance is adjustable.) �To adjust the balance of the front speakers While outputting the test signal, press [2, 1]. �Adjust the speaker level to the same level as the front speakers.

SETUP MUTING

Muting

Press [MUTING].
�MUTING� flashes on the unit�s display.

To stop the test signal Press [SHIFT]i[TEST] again.

� To adjust speaker level during play
(Effective when playing multi-channel audio or when Dolby Pro Logic II or Super Surround is on.)

C

1

Press [CH SELECT] to select the speaker.
L #C #R #RS #LS #SW ^-------------------------------------------------} SW: Subwoofer �You can adjust SW only if the disc includes a subwoofer channel. ��SW� does not appear on the display and is not adjustable when Dolby Pro Logic II is turned on. ��S� appears on the display when �MUSIC� or �MOVIE� is selected with Super Surround (� page 22). In this case, you can adjust both surround speaker levels at the same time using [3, 4]. S: `6 dB to i6 dB

To cancel �Press [MUTING] again or reduce the volume to minimum (-- -- dB), then raise it to the required level. �Muting is canceled when you switch the unit to standby.

Using headphones
Main unit only

1
Reduce the volume and connect the headphones (not included).
Headphone plug type: 3.5 mm (1/8z) stereo

2

Press [3] (increase) or [4] (decrease) to adjust the speaker level for each speaker.
POWER

VOLUME
AC IN

C, RS, LS, SW: `6 dB to i6 dB (L, R: Only the balance is adjustable.) �To adjust the balance of the front speakers While �L� or �R� is selected, press [2, 1].
OPEN CLOSE DISC CHANGE DISC DISC CHECK

VOLUME

TUNE MODE

FM MODE

MEMORY

TUNING

DOWN

UP

SELECTOR PROGRESSIVE CD MODE
PHONES

1

2

3

4

5

2
[Note]

Adjust headphone volume with [VOLUME].
�Audio is automatically switched to stereo (2-channel).

Avoid listening for prolonged periods of time to prevent hearing damage.

RQT7969

23

functionsusefulquality/OthersoundandfieldSound