PANASONIC SAAK220
Manual de Usuario

Radio
Preset tuning
Remote control only
There are two methods of pre-setting stations. Automatic presetting : All the stations the tuner can receive are preset. Manual presetting : You can select the stations to preset and the order they are preset in. Up to 15 stations each can be set in the FM and AM bands. Preparation: Press [TUNER, BAND] to select �FM� or �AM�.

Automatic presetting
Do the following once each for FM and AM. Preparation: Tune to the frequency where pre-setting is to begin.

Hold down [PROGRAM] until the frequency changes.

The tuner presets all the stations it can receive into the channels in ascending order. When finished, the last station memorized is tuned in.

Manual presetting
Pre-set the stations one at a time. 1 Press [PROGRAM] then press [g, REW/3 ] or [f, 4/FF] to tune to the desired station. 2 Press [PROGRAM] then press [g, REW/3 ] or [f, 4/FF] to select a channel. 3 Press [PROGRAM].

Manual tuning
1 Press [TUNER, BAND] to select band.
The unit comes on. Every time you press the button: FM � AM

The station occupying a channel is erased if another station is preset in that channel.

Selecting channels Press the numbered buttons to select the channel.
To enter channel 10 or over, press [X10], then the two digits.

2 Press [PLAY MODE] on the remote control to select
�MANUAL�.
Every time you press the button: MANUAL � PRESET OR

3 Hold down [g/REW/3] or [f/FF/4] for a moment
to search for a station.
The frequency stops when it finds a clear station. To stop during the process, press [g/REW/3] or [f/FF/4]. Under excessive interference, a station may not be found. Press [g/REW/3] or [f/FF/4] repeatedly to tune step-bystep. �TUNED� is displayed when a radio station is tuned. �ST� is displayed when a stereo FM broadcast is being received.

1 Press [PLAY MODE] to select �PRESET�. 2 Press [g, REW/3] or [f, 4/FF] to select the channel.

If noise is excessive in FM
Remote control only

Hold down [PLAY MODE] to display �MONO�.
Monaural sound is selected and noise reduces when reception is weak. Hold down [PLAY MODE] again to cancel the mode. �MONO� is also cancelled if the frequency is changed.

To receive FM broadcasts allocated in 0.1 MHz steps
Main unit only Hold down [TUNER, BAND]. The display changes in a few seconds to show the current minimum FM frequency. Continue to hold down the button until the minimum frequency changes. The step is changed. Repeat the above to change the step back. Note

�

10
RQT7528

�

After changing the �allocation� setting, the frequencies you previously preset in the memory will be cleared. Sound is momentarily interrupted if you load/unload tapes while listening to an AM broadcast.