|
Usuarios conectados
Actualmente hay 5756 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
� Place speakers equal distances from your listening position for good stereo sound. Use speaker cords of the same length for each speaker.
Attaching the spikes
A set of four metal spikes is supplied that you can use to isolate the speaker from the floor. We recommend using the spikes over the supplied non-slip pads as they will improve the sound of the speaker.
1 Spike
Speaker base
50 � 60º
Nut
2
� If you�re using these speakers for your TV sound, install them at equal distances either side of the TV and point them in the same direction as the TV. � If the room has a lot of reverberation, we recommend hanging heavy fabric on the walls, and/or putting a carpet on the floor to damp the sound. For best results, cover walls completely. � Do not place the speaker where it will be in direct sunlight, and avoid positioning it near heaters and air conditioners. This may cause warping and discoloration of the speaker cabinet and damage the speakers. � The speaker is heavy. Placing it on an unstable surface is dangerous, and should be avoided.
For each spike: 1 Screw the nut all the way onto the spike.
2 Screw the spike into the base of the speaker. There are four holes for the spikes in the base of the speaker cabinet. 3 Place the speaker upright so that the spikes are resting on the spike bases on the floor. 4 Adjust the spike lengths by unscrewing them slightly from the speaker cabinet. Adjust so that the speaker is resting squarely on all four spikes. 5 Tighten the nut up against the base of the speaker.
Attaching the non-slip pads
Pioneer assumes no liability whatsoever for damages resulting from assembly, improper mounting, insufficient reinforcement, misuse of the product, acts of nature, etc. A set of four self-adhesive non-slip pads are supplied that you can use in place of the spikes to provide some isloation and also prevent the speakers moving. 1 Remove the backing tape of the non-slip pads and stick one in each corner on the base of the speaker.
Speaker base
2
|
|
|
> |
|