JVC RX-ES9SLEN
Manual de Usuario

Tuner operations
3 Press the numeric buttons (1 � 10, +10) to select
a channel number while the channel number position is flashing.
TV DIRECT SETTING ADJUST SURROUND SET / TUNER PRESET
STANDBY / ON STANDBY

On the front panel:
SOURCE SELECTOR / MULTI JOG MASTER VOLUME PHONES

DVD MULTI

DVD

STB

VR

TV

FM / AM

� For channel number 5, press 5. � For channel number 15, press +10, then 5. � For channel number 30, press +10, +10, then 10.
ANALOG L SUBWFR R TUNED ST AUTO MUTING MHZ VOL

Before you start, remember... There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

4 Press MEMORY again while the selected channel
number is flashing on the display.
The station is assigned to the selected channel number. � The selected channel number stops flashing.
ANALOG L SUBWFR R TUNED ST AUTO MUTING MHZ VOL

1

Turn SOURCE SELECTOR to select �FM� or �AM.�
The last received station of the selected band is tuned in.

2 Press TUNER PRESET.
�P� appears on the display and MULTI JOG now works for selecting preset channels.

3 Turn MULTI JOG to select a preset channel 5 Press repeatedly or hold TUNING 9 or
to store. number during �P� appears on the display.
� Turning MULTI JOG clockwise increases the preset channel numbers. � Turning MULTI JOG counterclockwise decreases the preset channel numbers.

TUNING ( to select another frequency you want

6 Repeat steps 1 to 5 until you store all the
stations you want.
To erase a stored preset station Storing a new station on a used channel number erases the previously stored one.
ANALOG L SUBWFR R TUNED ST AUTO MUTING MHZ VOL

Selecting the FM reception mode
When an FM stereo broadcast is hard to receive or noisy, you can change the FM reception mode while receiving an FM broadcast. � You can store the FM reception mode for each preset station (see page 23).

To tune in a preset station
From the remote control:

1 Press FM/AM to select the band.

The last received station of the selected band is tuned in and the numeric buttons now work for tuner operations. � Each time you press the button, the band alternates between FM and AM (MW).
ANALOG L SUBWFR R TUNED ST AUTO MUTING MHZ VOL

From the remote control ONLY: While listening to an FM station, press FM MODE.
If you select �FM� using SOURCE SELECTOR on the front panel, press FM/AM on the remote control before this operation. � Each time you press the button, the FM reception mode alternates between �AUTO MUTING� and �MONO.� AUTO MUTING*: Normally select this. When a program is broadcast in stereo, you will hear stereo sound; when in monaural, you will hear monaural sound. This mode is also useful to suppress static noise between stations. The AUTO MUTING indicator lights up on the display. MONO: Select this to improve the reception (but stereo effect will be lost). In this mode, you will hear noise while tuning in to the stations. The AUTO MUTING indicator goes off from the display. (The ST indicator also goes off.) * Initial setting

2 Press the numeric buttons (1 � 10, +10) to select
a channel number.
If you select �FM� or �AM� using SOURCE SELECTOR on the front panel, press FM/AM on the remote control before this operation. � For channel number 5, press 5. � For channel number 15, press +10, then 5. � For channel number 30, press +10, +10, then 10.
ANALOG L SUBWFR R TUNED ST AUTO MUTING MHZ VOL

24