Tuning in to stations manually
From the remote control ONLY:
1 Press FM or AM to select the band.
The last received station of the selected band is tuned in.
ANALOG L R TUNED STEREO S.WFR MHz AUTO MUTING
Tuner operations are mainly done from the remote control.
2 Press repeatedly or hold TUNING 9 or
( TUNING until the station you want is tuned in.
� Pressing (or holding) TUNING 9 increases the frequency. � Pressing (or holding) ( TUNING decreases the frequency.
FM
AM
NOTES � When you hold and release TUNING 9 or ( TUNING, the frequency keeps changing until a station is tuned in. � When a station of sufficient signal strength is tuned in, the TUNED indicator lights up on the display. � When an FM stereo program is received, the STEREO indicator also lights up.
FM MODE
TUNING/REW
MEMORY
FF/TUNING
Using preset tuning
Once a station is assigned a channel number, the station can be quickly tuned simply by selecting the number. You can preset up to 30 FM and 15 AM stations.
1 4 7 10 2 5 8 0 3 6 9 10
To store the preset stations
Before you start, remember... There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.
NOTE When you have selected �FM� or �AM� by using SOURCE SELECTOR on the front panel, the remote control may not work for tuner operations. To use the remote control for tuner operations, select �FM� or �AM� by using FM or AM button on the remote control.
From the remote control ONLY:
1 Tune in to the station you want to preset
(see �Tuning in to stations manually� above).
� If you want to store the FM reception mode for this station, select the FM reception mode you want. See �Selecting the FM reception mode� on page 28.
ANALOG S.WFR L R TUNED STEREO AUTO MUTING
Setting the AM tuner interval spacing
Some countries space AM stations 9 kHz apart, and other countries use 10 kHz spacing. 9 kHz interval spacing is the initial setting. � Be sure the receiver is turned off, but is plugged into an AC outlet when setting the AM tuner interval.
MHz
2 Press MEMORY.
The channel number position starts flashing on the display for about 5 seconds.
ANALOG L S.WFR MHz R TUNED STEREO AUTO MUTING
On the front panel ONLY:
To select the 10 kHz interval: Hold down ADJUST and press STANDBY/ON. �10k STEP� appears on the display. To change back to the 9 kHz interval: Hold down SETTING and press STANDBY/ON. �9k STEP� appears on the display. NOTE When you change the AM tuner interval spacing, stored preset stations are erased. In this case, restore stations.
