JVC RX-D202BJ
Manual de Usuario

3 Press the numeric buttons (1 � 10, +10) to
English
select a channel number while the channel number position is flashing.
� For channel number 5, press 5. � For channel number 15, press +10, then 5. � For channel number 30, press +10, +10, then 10.
ANALOG L S.WFR MHz R TUNED STEREO AUTO MUTING

On the front panel:

2 1,3

Before you start, remember... There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 2 again.

4 Press MEMORY again while the selected
channel number is flashing on the display.
The selected channel number stops flashing. The station is assigned to the selected channel number.

1 Turn SOURCE SELECTOR to select �FM� or
�AM.�
The last received station of the selected band is tuned in.

2 Press TUNER PRESET.
�P� appears on the display, and MULTI JOG now works for selecting preset channels.

5 Repeat steps 1 to 4 until you store all the
stations you want.
To erase a stored preset station Storing a new station on a used channel number erases the previously stored one.

3 Turn MULTI JOG to select a preset channel
number.
� To increase the preset channel numbers, turn MULTI JOG clockwise. � To decrease the preset channel numbers, turn MULTI JOG counterclockwise.

To tune in a preset station
From the remote control:

1 Press FM/AM to select the band.
The last received station of the selected band is tuned in and the numeric buttons now work for tuner operations. � Each time you press the button, the band alternates between FM and AM.
ANALOG L S.WFR MHz R TUNED STEREO AUTO MUTING

Selecting the FM reception mode
When an FM stereo broadcast is hard to receive or noisy, you can change the FM reception mode while receiving an FM broadcast. � You can store the FM reception mode for each preset station (see page 25).

From the remote control ONLY: While listening to an FM station, press FM MODE.
� Each time you press the button, the FM reception mode alternates between �AUTO MUTING� and �MONO.� AUTO MUTING Normally select this. When a program is broadcast in stereo, you will hear stereo sound; when in monaural, you will hear monaural sound. This mode is also useful to suppress static noise between stations. The AUTO MUTING indicator lights up on the display. Select this to improve the reception (but stereo effect will be lost). In this mode, you will hear noise while tuning in to the stations. The AUTO MUTING indicator goes off from the display. (The STEREO indicator also goes off.) Initial setting: AUTO MUTING

2 Press the numeric buttons (1 � 10, +10) to
select a preset channel number.
ANALOG L S.WFR MHz R TUNED STEREO AUTO MUTING

� For channel number 5, press 5. � For channel number 15, press +10, then 5. � For channel number 30, press +10, +10, then 10.

MONO

26