On the front panel: You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.
8. ONLY FOR JVC Theater Surround: Press cursor control @ / # to select an effect level you want.
� Each time you press the button, the effect level changes as follows:
1. Press SURROUND repeatedly until the mode � �PROLOGIC� or �3 STEREO� or �THEATER��appears on the display.
The PRO LOGIC indicator lights up on the display.
SURROUND
EFFECT 1
EFFECT 2
EFFECT 3
EFFECT 5
ADJUST
EFFECT 4
2. Press ADJUST so that the cursor control % / � / @ / # buttons work for adjusting the DSP setting. 3. Press cursor control % / � repeatedly until ��CENTER+� appears on the display.
As the number increases, JVC Theater Surround becomes stronger.
Activating the DSP Modes
Once you have finished adjustments for the DSP modes, you can use the same adjustments every time you want to use these modes.
On the front panel:
SURROUND
4. Press cursor control @ / # to adjust the center speaker output level (from �10 to +10).
1. Press SURROUND repeatedly until the DSP mode you want appears on the display.
� Each time you press the button, the DSP modes change. (See page 16 for more details)
2. Select and play a sound source. 5. Press cursor control % / � repeatedly until �� REAR +� appears on the display.
� To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with Dolby Surround and is labeled with DOLBY SURROUND mark.
To cancel the DSP mode
Press SURROUND repeatedly until �OFF� appears on the display.
6. Press cursor control @ / # to adjust the rear speaker output level (from �10 to +10).
Note:
You cannot adjust the left and right rear speaker output levels separately.
From the remote control:
1. Press SOUND CONTROL.
The 10 keys are activated for sound adjustments.
SOUND CONTROL
2. Press SURROUND repeatedly until the DSP mode you want appears on the display.
� Each time you press the button, the DSP modes change. (See page 16 for more details)
SURROUND
3
7. ONLY FOR JVC Theater Surround: Press cursor control % / � repeatedly until ��EFFECT+� appears on the display.
3. Select and play a sound source.
� To enjoy the 3D-PHONIC, Dolby Surround, and JVC Theater Surround, play back a software which was processed with Dolby Surround and is labeled with DOLBY SURROUND mark.
To cancel the DSP mode
Press SURROUND repeatedly until �OFF� appears on the display in step 2 above.