WHIRLPOOL RT14FCLWL00
Manual de Usuario

Adjusting refrigerator shelves
Shelves can be adjusted to match the way you use your refrigerator

Ice cube trays
Remove ice by slightly twisting the tray with both hands.
NOTE: The longer ice cubes are stored.

Energy saving tips
Check the doorrefrrgerator to tight seal. Level the gaskets for a be sure of a good seal. Clean dust and lint from the condenser coils every other month. Open the doors as seldom as possible. Decide what you need before you o;jerr the door. Remove everything you need at one time. Organize and label food so you will not have to search for items you want. Close door immediately after you remove food items. Store food in the refrigerator and freezer so that air movement is not blocked. Set the refrigerator temperature so that the drinks remain cold enough for your family�s taste and ice cream remains firm. Do Not se! temperature colder than it needs to be. Set the Exterior Moisture Control to the OFF position unless moisture forms on the outside of the refrigerator. mDo Not install your refrigerator next to your range, water heater, furnace, radiator, other heat sources or in direct sunlight.

the smaller they get. Slow evaporation is caused by the movement of cold air.

Changing the light bulb

I
To remove:
1. Remove food from shelf. 2. Slide shelf straight forward to the guide stops. 3. Lift front until shelf clears stops, then slide shelf out the rest of the way.

Electrical Shock Hazard Unplug the refrigerator or disconnect the main electric power supply to the refrigerator before changing a bulb. Failure to do so can result in electrical shock or iniunr.

I

To replace:
1. Fit back of shelf on top of guides with wire stops on the bottom of the guides. 2. Lift front and slide shelf in until it clears guide stops. Slide shelf in the rest of the way.

Food storage suggestions
1. Disconnect refrigerator from power SUPPlY� 2. Reach behind the Control Console to find bulb 3. Remove bulb. 4. Replace with a 40-watt appliance bulb.
5. ReCOMeCt power Supply. NOTE: Not all commercial appliance

Removing crisper and crisper cover Lift the back,

then slide out
) the rear d lift out.

Food placed in the refrigerator should be wrapped or stored air and food odor proof material. Thisinprevents moisture and taste transfer throughout the refrigerator. For dated products, check code date to ensure freshness. The freezer section is designed for storage of commercially frozen food and for freezing food at home. For further information about preparing food for freezing or food storage times, contact your local Cooperative Extension Service or check a freezer guide or cookbook.

bulbs will fit your refrigerator. Be sure to replace a bulb with one of the same size and shape.

Freezing
Do not expect your freezer to quickfreeze any large quantity of food. Put no more unfrozen food into the freezer than will freeze within 24 hours. (No more than 2 or 3 pounds of food per cubic foot of freezer space.) Leave enough space for air to circulate around packages. Be careful to leave enough room at the front so the door can close tightly. Storage times will vary according to the quality of the food, type of packaging or wrap used (air and moisture proof), and storage temperatures which should be 0°F (-17S�C).

To remove crisper:
1. Slide crisper straight out. 2. Replace in reverse order. To remove cover: 1. Lift back, then slide to the rear until the front can be lifted. 2. Lift cover up and out.

Normal operating sounds
You can expect to hear the following sounds when your refrigerator-freezer is operating: . Water sounds as water gurgles through tubing for a few minutes after refrigerator stops running. YOU may also hear defrost water running into the defrost water pan. . Operating sounds from the highefficiency compressor and motor. It may run longer than your older refrigerator.

To replace cover:
1. Slide the front cover tabs in from the rear of the front supports on the refrigerator walls. 2. Lower back of cover into place.