PHONIC ROAD GEAR260
Manual de Usuario

Some Important Information
The Combination Docking Lock The docking locks of the RoadGear are combination locks, which require the user to enter a pre-set combination to open them. Please observe the following instructions to opening the lock. 1) The default code of the lock is 000. Please enter this code the �rst time you use the RoadGear. 2) To change the lock�s code, �rst open the latch and �nd a small lever on the underneath of the lock. Pull it towards the centre of the lock and up until it sticks into place.

Underneath The RoadGear Combination Lock

3) Change the code dials to your desired secret code. Ensure you either remember the code by heart or write it down somewhere, so as to not have to attempt to break the RoadGear apart in a way that would not be favorable to your equipment. 4) After entering your desired code, replace the small lever underneath the lock into its original position. And Voila! Your new, secret code is set. Latch Position Please ensure, after unpacking the RoadGear set, that the docking locks on the speakers are locked back into place, to ensure the locks do not scratch the surface on which the speaker is standing.

PHONIC CORPORATION

RoadGear User's Manual

page 13