PROGRAMMING A TELEVISION�S INTERNAL MEMORY
WRITING TV MEMORY
After the Memory has been read from one television, the Clon99-BK SmartLoader is now ready to write the memory to other televisions. This memory can be written with or without certain settings. These settings include: Picture Adjustment, Minimum and Maximum Volume, and the On Volume settings.
BEGIN
Clon99-BK SmartLoader Box
1
EXTERNAL SPEAKER 75� ANT/ CABLE
Typical rear jack panel of ITV
ON/OFF Slide Switch
SMART PLUG
Plug one end of the cable into the jack provided on the SmartLoader. Then plug the other end into the jack provided on the back of the TV. The TV jack is next to the Antenna Input terminal. Push the Slide Switch to the ON position on the SmartLoader. If the TV is currently off, it should turn on within 15 seconds. Within 20 seconds, the SmartLoader on-screen display should appear on the TV screen. If the display does not appear, check connections and push the Slide Switch to the ON position again. If there is still no response from the SmartLoader, replace its 9-volt battery. Press the POWER button on the remote to display the Clon99-BK SmartLoader Setup Menu. With the Setup Menu visible, press the Number 2 button on the Remote Control to select the 2nd option �Write TV With Settings� or press the Number 3 button to select the third option �Write TV Without Settings.� The screen will ask �Write?� Press the 0 button on the remote to confirm and begin the procedure. The screen will indicate �Writing Block 24 of 63� while the Clon99-BK SmartLoader is downloading the data. The display will then read �Finished Writing Memory� when the procedure has been completed.
A VOL MUTE B E C F A/CH SLEEP
2
3
PHILIPS SMARTLOADER 99
Copyright PCEC 1999 System Version D.0 PN 3135 019 01681
PRESS POWER TO BEGIN
LED
Philips SmartLoader 99 System Version D.0 1 - Read TV 2 - Write TV With Settings 3 - Write TV Without Settings 4 - Erase SmartLoader Memory 5 - System Test 6 - Exit SmartLoader Stored Memory Type 01, 04
RECALL
-
SELECT
M
+
Philips SmartLoader 99 System Version D.0
CH
1 - Read TV
2 - Write TV With Settings 3 - Write TV Without Settings
D G
5 7
4 - Erase SmartLoader Memory 5 - System Test 6 - Exit SmartLoader Write? Press 0 to confirm
RESET
1 4 7
2 5 8 0
3 6 9
CC
Philips SmartLoader 99 System Version D.0 1 - Read TV 2 - Write TV With Settings
CH GDE
3 - Write TV Without Settings
POWER
TV GUEST
TV SETUP
DCM SETUP
6 8
4 - Erase SmartLoader Memory 5 - System Test 6 - Exit SmartLoader Writing Block 23 of 63
4
Philips SmartLoader 99 System Version D.0 1 - Read TV 2 - Write TV With Settings 3 - Write TV Without Settings 4 - Erase SmartLoader Memory 5 - System Test 6 - Exit SmartLoader Finished Writing Memory
