INTEGRA RDC7
Manual de Usuario

Enjoying music or videos with the RDC-7
Using the many features of the RDC-7
Outputting from different input source: You can have the RDC-7 output the audio of one input source through the speakers while the video of another input source is output to the monitor (see �2-3. Video Setup sub-menu� on page 38). Assigning names to input sources: You can enter a name for each input source so that when the source is selected the name of that source is displayed in the front display of the RDC-7 (see �2-7. Character Input sub-menu� on page 43). Temporarily changing the speaker output levels: To change the individual speaker volumes temporarily, use the remote controller and follow the procedure given below. Note that the calibration settings will return to the original settings when the RDC-7 is put in standby. 1. Press the CH SEL button and select the desired speaker. 2. Press the LEVEL + or � button to adjust the volume level. Using the sleep time: To set the sleep timer, press the SLEEP button on the remote controller and then set the time that you want the RDC-7 to enter the standby state (see page 60). Temporarily turning off the sound: To turn off the sound momentarily, such as when interrupted by a phone call, press the MUTING button on the remote controller (see page 61). Adjusting the bass and treble: You can adjust the bass and treble levels at the Sound Effect sub-menu of the OSD menu: Input Setup � Sound Effect (see page 42). Adjusting the brightness of the front display: You can adjust the brightness of the front display of the RDC-7 with DIMMER button on the remote controller or on the RDC-7 front panel (see page 61).

Enjoying the multichannel output
Before you can use a component with multichannel output, you must first select �Yes� for the Multichannel setting in the OSD menu for that input source: Input Setup � Multichannel Setup (see page 38).

1. Press the input source button for the component with multichannel output connected to the MULTI CHANNEL INPUT on the rear of the RDC-7. 2. Turn on the connected component and start playing the desired media. 3. If necessary, press the CH SEL button on the remote controller to select an individual speaker. Then press the LEVEL + or � button to adjust the output level as desired.
Adjust the speaker output levels so that you can hear the same sound level from each speaker at the listening position. For the front right, front left, center, surround right,surround left, surround back right and surround back left speakers, the output levels can be adjusted between �12 to +12 decibels. The subwoofer can be adjusted between �30 and +10 decibels.

4. Adjust the volume with the MASTER VOLUME dial or the VOL controller. buttons on the remote

If one of the messages shown below appears
If one of the messages shown below appears in the front display, it is telling you that the operation you are trying to perform is not possible for the reason given in the message.

The operation is not allowed because headphones are plugged into the RDC-7.

The operation is not allowed because the selected input source is set for multichannel input.

The operation is not allowed by the current speaker configuration.

No setting other than Dolby Digital can be set.

57