Reassembly Note: 1. Gear Alignments The Supply Loading Arm Unit and the Loading Gear The Supply Loading Arm Unit and the Main Cam Unit (1) Confirm that Hole A on the Main Cam Unit is a Through Hole with a hole on the chassis by rotating the Main Cam Unit clockwise as much as possible. Also, make sure the Loading Gear makes contact with contact point. (2) Set the Supply Loading Arm Unit so that the last tooth of its lower gear is just outside the last tooth of the Loading Gear as shown. (3) Turn the Main Cam Unit counterclockwise first 1 , then turn Supply Loading Arm Unit clockwise slightly 2 so that the last tooth on upper gear of Supply Loading Arm Unit is just outside tooth (a) of Main Cam Unit. Supply Loading Arm Unit Loading Gear
(4) Confirm that Hole A, B, and C are Through Holes by rotating the Main Cam Unit. Hole C
Through Hole
Supply Loading Arm Unit Chassis
Through Hole
Loading Gear Chassis
Hole B
Supply Loading Arm Unit
Main Cam Unit
Hole A Contact point 2 Lower Gear
last tooth last tooth
Through Hole
Main Cam Unit
Standby Position 1 Top View Fig. DM21-3
Chassis
Main Cam Unit Fully Loaded (Play) Position
Through Hole
Main Cam Unit Chassis
Hole A
Upper Gear Supply Loading Arm Unit
last tooth tooth (a)