*Important: If a remote control button does not work when pressed, press the and try the button again.
button on the remote
Manual Clock Set
If AUTO CLOCK SET was incomplete, manually set the clock as follows.
Reset all unit Memory Functions
When moving unit to a new location, or if a mistake was made in the Initial Setup section. � Make sure a tape is not inserted in the unit.
Initial Setup
1
Press ACTION on the Remote to display SET CLOCK Menu screen.
SET CLOCK DST : ON SELE CT MONTH SELECT : SET : SET END : ACT I ON
2
Press to select the month and press SET to set. In the same manner, select and set the date, year, time, and DST. (Daylight Saving Time)
1 Turn the unit Power on. 2 Press and hold both PLAY and FF
on the unit for more than 5 seconds.
� The power will shut off. � Please ignore �NO CASSETTE� warning.
3 Perform �Initial Setup� on page 14.
3
Press ACTION twice to start CLOCK and exit.
Note to CABLE system installer:
This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
