ortant: If a remote control button does not work when pressed, press the on the remote and try the button again.
button
anual Clock Set
TO CLOCK SET was incomplete, manually he clock as follows.
Reset all unit Memory Functions
When moving unit to a new location, or if a mistake was made in the Initial Setup section. � Make sure a tape is not inserted in the unit.
Press ACTION on the Remote to display SET CLOCK Menu screen.
SET CLOCK
1/ /
SELE SE CT MONTH SELECT : SET : SET END : ACT I ON
:
DST : ON
Press to select the month and press SET set. In the same manner, select and set the date, year, time, and DST. (Daylight Saving Time)
SET CLOCK
1 2
Turn the unit Power on. Press and hold both PLAY and FF on the unit for more than 5 seconds.
� The power will shut off. � Please ignore �NO CASSETTE� warning.
2 / 6/2002 WED 12: 00PM PM
DST : ON SET SE COMPLETED SET START : SET : ACT I ON
3
BACK:
Do �Initial Setup� on page 14.
Initial Setup
Press ACTION twice to start CLOCK and exit.
Note to CABLE System Installer
This reminder is provided to call the CABLE (Cable TV) System Installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
