6. After adjustment, confirm that the tape travels without curling at P2 and P3 posts.
Fig. M4-3
7. Remove the jumper after completing the adjustment procedure.
7.2.2.3.2. AUDIO CONTROL HEAD TILT ADJUSTMENT
Purpose: To confirm that the tape runs smoothly. In particular, confirm that the tape properly picks up the Audio Signal at the upper part of the head and the Control Signal at the lower part of the head. Symptom of Misadjustment: If the tilt of the Audio Control Head is poorly adjusted, the tape will eventually be damaged. An intermittent Blue screen may be seen in Playback. 1. Play back a T120 cassette tape and check that the tape travels smoothly between the upper and lower guides of the P4 post. 2. If necessary, adjust Black Screw (B) clockwise until the tape begins to curl at the lower edge of the P4 post. Then adjust the screw counterclockwise until the curling is eliminated.
Fig. M5
7.2.2.3.3. AUDIO CONTROL HEAD HEIGHT ADJUSTMENT The height of the Audio Control Head replacement part is preset at the factory.
Purpose: To be sure the tape runs properly along the Control Head.