This should normally be set to �ON�. ON When the power is turned on, the projector detects which signal is being input, and uses that signal for projection. OFF Use this setting when you do not want the signal source to be changed automatically when the power is turned on.
This setting should be changed in accordance with the projector setting-up method. (Refer to page 18.) DESK When the projector is placed on a desk or similar. CEILING When the projector is suspended from a ceiling using the ceiling bracket (sold separately).
The projector will return to standby mode after the duration of the period you set has passed. The period can be set from 60 minutes to 240 minutes in 30 minute intervals. The remaining time will be displayed 3 minutes before the projector returns to standby mode. The setting will be cancelled if set to �OFF� before reaching the duration of the period you set.
This setting changes the lamp brightness. When set to �LOW�, the luminance of the lamp is reduced, but the projector uses less power, and the operating noise is also reduced. The �LOW� setting is recommended for narrow rooms where a high picture luminance is not essential or for watching movies. NOTE: B �LAMP POWER� cannot be set when no signal is being input.
FRONT/REAR
BACK COLOR
This setting should be changed in accordance with the projector setting-up method. (Refer to page 18.) FRONT When the projector is placed in front of a screen. REAR When using a translucent screen. ON The �Panasonic� logo will be displayed when the power is turned on. OFF The �Panasonic� logo will not be displayed when the power is turned on.
LAMP RUNTIME
This setting displays the usage time for the lamp unit which is currently being used. When replacing the lamp unit, follow the instructions on page 58, and reset �LAMP RUNTIME� to �0�. NOTE: B The lamp�s operating life varies depending on the usage conditions (such as the �LAMP POWER� setting and the number of times the power is turned on and off).
This sets the color which is projected onto the screen when no signal is being input to the projector.
STARTUP LOGO
FAN CONTROL
Set �FAN CONTROL� to �HIGH�, when using this projector at high elevations (above 1 400 m) only.
