|
|
|
Usuarios conectados
Actualmente hay 5825 visitantes online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
PT-56DLX76 / PT-61DLX76 / PT-61DLX26
COLOR WHEEL INDEX DELAY ADJUSTMENT
Purpose: To set the standard color index. Symptom of Misadjustment: Many vertical stripes will appear.
OTHER O O C W D G P P W B D C T T HPOSI 8000 VPOSI 8000 INDEX DELAY00FD 00 1/1
1. Display the Red ramp pattern by pressing the ASPECT key. 2. Adjust "CW INDEX DELAY" value by pressing the VOLUME UP/DOWN key so that red ramp pattern is even, with no discoloration.
OTHER O O C W D G P P W B D C T T HPOSI 8000 VPOSI 8000 INDEX DELAY00F0 00 1/1
P :05060101
P :05060101
<Red ramp pattern>
Fig. E5-1 3. Display the Green ramp pattern by pressing the ASPECT key. 4. Confirm the green ramp pattern is even, with no discoloration. If not, adjust "CW INDEX DELAY" value by pressing the VOLUME UP/DOWN key.
OTHER O O C W D G P P W B D C T T HPOSI 8000 VPOSI 8000 INDEX DELAY00F0 00 1/1
SET UP: 1. Install the Projection Unit into the Cabinet. 2. Enter Work Mode. Then, enter Factory Adjust Mode. 3. Press the CH UP/DOWN key on the remote to select "OTHER" on menu and press the OK key. (Other menu will appear.) 4. Press the CH UP/DOWN key on the remote to select "CW INDEX DELEY" on menu and press the ASPECT key once to select "Red ramp pattern." To release this mode: 1. After completing the adjustment, press the CH UP/DOWN key on the remote to return to the Other menu. 2. Then, press RECALL key twice to return to Work Mode, and turn off the power.
P :05060101
<Green ramp pattern>
Fig. E5-2 5. Display the Blue ramp pattern by pressing the ASPECT key. 6. Confirm the blue ramp pattern is even, with no discoloration. If not, adjust "CW INDEX DELAY" value by pressing the VOLUME UP/DOWN key.
OTHER O O C W D G P P W B D C T T HPOSI 8000 VPOSI 8000 INDEX DELAY00F0 00 1/1
P :05060101
<Blue ramp pattern>
Fig. E5-3 7. Repeat the above steps until all patterns are even, with no discoloration. Note: After this adjustment, do not copy using the EEP COPY L->DG in the Factory Adjust Mode. Otherwise, the factory default data of the Projection Unit will be copied to EEPROM IC on the Main P.C.B., and re-adjustment will be necessary.
62
|
|
|
> |
|
