Reassembly Notes for Mirror: Install the Mirror as following procedures. 1) Peel the Protection Sheet approx. 20 mm (maximum 22 mm) from the top and bottom edges of the Mirror to place the Sheet. Then, place the 4 sheets on the top and bottom edges of the Mirror as shown.
Top edge of Mirror Sheet
Sheet
Sheet
Protection sheet
Mirror
Mirror support bracket
Sheet
Sheet
Sheet
Bottom edge of Mirror
Mirror
<Front View> Fig. D5-3-1
Fig. D5-3-2 Top Mirror Plates 2) When handling the Mirror, do not touch the Mirror surface. Be sure to hold the sheet portions of the Mirror. 3)
CAUTION: Insert the Mirror from the top into the lower slots (For model with 40 inch Mirror) or into the upper slots (For model with 45 inch Mirror) of the Back Panel carefully avoiding the Mirror Support Brackets. Otherwise, the Mirror may crack. Then, the Mirror is secured with the Mirror Support Brackets.
Screws "b"
Back Panel
Mirror (Protection Sheet)
Upper Slots (for model with 45 inch Mirror) Lower Slots (for model with 40 inch Mirror)
4) Install the 2 Top Mirror Plates on the Mirror and tighten the 4 Screws. 5) Peel the Protection Sheet from the Mirror.
