PHILIPS PSA410/05
Manual de Usuario

Power supply
You can use the following batteries with this CD-player: > PHILIPS rechargeable batteries, HF18/07/68

Inserting rechargeable batteries 1
Press and lift to open the CD lid.

2

Open the battery compartment (inside the CD player).

3

Insert batteries with correct polarity. Remove batteries if the player is not going to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

x2

Charging 1 2 3
Insert the rechargeable battery. Connect the power adapter to the 4.5V DC jack of the player and then to the wall outlet. Recharging stops after battery is full or when you start playback. When the battery is fully recharged, BATT FULL appears in the display. The approximate power level of your batteries is shown on the display.

�

TIP > It is normal for the batteries to become warm during recharging. > If the batteries become too warm, recharging will be interrupted for approximately 30 minutes. > To ensure proper recharging on board, take care that contacts are clean. > Recharging already charged or half-charged batteries will shorten their lifetime. We therefore recommend that you let the rechargeable battery run till it is completely empty before you recharge it. > To avoid a short circuit, do not let the battery touch any metal object. > If the battery becomes empty soon after recharging, then either its contacts are dirty or it has reached the end of its lifetime.

2