Warranty Certificate � Customer Service � Warnings
7
Piccolo Italian Prestige Rigid Turntable
Troubleshooting
SYNPTOM
BELT NOISE DURING PLAY (GREEN BELT)
DESCRIPTION
The Green Belt makes a noise during playing
CAUSE
� Because its low elasticity and the presence of ceramic particles the characteristics of the green belt make it noisier than usual rubber black belts; It does not affect the sound � Because its low elasticity and the presence of ceramic particles the characteristics of the green belt make it wobbles a little around the motor pulley; It does not affect the sound � AC synchronous motors as the ones used by Bluenote normally warms up to 50° Celsius without creating any problem � The pulley�s shaft slightly touches the motor gold plated cover � Your turntable has a serial number before the 11650
REMEDY
� If a quieter belt is requested ask your local dealer for one of the newest Bluenote Black Rubber Belts
BELT WOBBLING DURING PLAY (GREEN BELT)
The Green Belt wobbles during playing
� If a not wobbling belt is requested ask your local dealer of the newest Bluenote Black Rubber Belts
MOTOR HEATING
The Motor warms up too much
MOTOR NOISE
The Motor produces a low scraping noise during playing The Motor produces a scraping noise during playing The Motor produces a buzz noise during playing
� Gently lift it up a bit unscrewing the hex bolt of the pulley � Ask your local dealer to change the internal capacitor filters the AC voltage and add the newer Teflon® washer at the motor spindle bottom � Unscrew them enough to let the motor spins without making noise, they need just to be very gently screwed to the motor cover � Clean it up, the oil will never comes out again once the Platter spindle is perfectly positioned into the Platter Bearing �
� The 3 stainless steel screws of the gold plated motor cover are too tighten � The super high pressure created by the strict tolerance of the Bearing/Spindle system can let some oil drops come out from the bottom of the Platter Bearing � Clamp the Spindle tip into the above side of the platter screwing it strongly using a metal pin to get into the tip hole � The Turntable Platter Bearing Bolt is 10mm thick having a serial number before the 11500
OIL POORED FROM BRONZE BEARING
Oil drops come out the bottom Platter Bearing when the Platter Spindle is inserted The Platter looks bent on the Turntable board
PLATTER BENT
� Ask your dealer to have the new thicker Turntable Platter Bearing Bolt � adjust the pulley on the motor spindle bending it gently with the fingers until you find the perfect on axis spinning � a PERFECT on axis spinning must b found with a bit of e practice � With the Allen key supplied adjust the 2 hex bolts fix the pulley on the motor spindle until you find the
PULLEY WOBBLING
The DELRING Pulley evidently wobbles during turntable play mode
�
PULLEY WOBBLING
The Optional aluminium adjustable Pulley evidently wobbles during turntable
