SONY PFV-HD300
Manual de Servicio

1-6. Installation of the Optional Board

4. Turn the board levers in the direction of the arrow 1 after inserting the board to the end of the slot by hand.

Rear side n 1. Save the removed blank panel for later use. 2. Always attach the IFB shield parts attached to both sides of the blank panel, since they are the parts that use spurious radiation. 3. In order to maintain the cooling effect for the main unit, do not leave the slot open. Be sure to attach a blank panel to an empty slot. The connector panel attachment methods are divided into three types, depending on the slot number.

1

2

<Type 1> For slot No. 1 <Type 2> For slot Nos. 2 to 6, 9 to 14 <Type 3> For slot Nos. 7, 8

2 1 2 Board lever 1

The attachment methods for each type are explained below.
1

<Type 1> 1. Remove the five screws, and remove the IFB shield L, the IFB shield and the blank panel.

2 Board lever

1 Insert 2 Remove

5. Stick the slot label supplied with the optional board onto the board lever. 6. Install the board retainers. 7. Install the front panel. n When removing the board, turn the board levers in the direction of the arrow 2, and pull out the board toward you.

Blank panel IFB shield

PWH 3x6

PWH 3x6

PWH 3x6 IFB shield L

PFV-HD300 MM

1-5 (E)