ADJUSTMENT
Adjustment of Horizontal Zero Balance
� Release the tone-arm from the armrest to free. 1 �Turn the balance weight clockwise or counter clockwise until 2 the tone arm is balanced horizontally.
Be careful not to touch your finger to the stylus tip.
� Return the tone-arm to the armrest. 3
Illustration of Adjustment
The balance weight and cartridge are balanced, the tone-arm is held horizontal. Excessive forward advancement of the balance weight causes the cartridge side to be lowered. Excessive backward re-treatment of the balance weight causes the cartridge side to be raised.
NOTE
Adjustment of Stylus Pressure
�Hold the balance weight with one hand as shown in the 1 drawing, and rotate only counter ring to bring the numeral "0" of the ring into alignment with the center line on the tone-arm rear shaft.
Rotate this part
In case the balance weight moved, do the adjustment of horizontal zero balance again.
NOTE
�Turn the balance weight to present the reading on the gauge to 2 the designed stylus force of your cartridge.As the counter ring moves in step with the balance weight, proper stylus pressure can be selected by reading the graduated ring directly.
Rotate this part
NOTE
The appropriate stylus pressure (generally 3� 4g) needs to be set in order to generate the best performance. Please refer to the user's manual of the stylus.
Adjustment of Tone-arm Height
�The height of the tone-arm can be adjusted maximum 9mm by 1 adjust ring.
In case of 16mm cartridge height � Adjustment of tone-arm height do not need. In case of 25mm cartridge height � Adjustment of tone-arm height need to set 9mm(MAX).
Generally, the highest setting of the tone-arm provides the best performance with minimum skipping. However, the original setting can be made according to user's experiences. Please tighten the adjustment screw after setting the height.
