|
Usuarios conectados
Actualmente hay 6041 visitantes y 2 usuarios online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
PDR-509
Code
Symptom
Contents of Error
Defects related to the recording laser power
Possible Cause
� Defective laser diode � Trouble in RF detection � Defective RFT RFB circuit � Recording power is not sufficient. � Improper soldering, pattern short � Trouble with power supply � Unable to read ATIP or subcode � Defective laser diode � Defective focus drive circuits � Defective pickup � Improper soldering � Pattern short � Trouble of power supply If any hardware trouble occurs before displaying A� or d�, the unit stops displaying a code other than these codes. Therefore, these service codes are generated only for troubles with the disc.
Checkpoints
IC201 (PA9007A) IC101 (AK8563) IC363 (TC7S04F) IC364 (TC7S14F)
C�
The unit stops before it enters REC/PAUSE mode.
� Dirty or cracked disc � The optimum recording power cannot be obtained. � Trouble in RF detection. Defective pickup � Unable to focus because of dirt or
F�
The unit stops during playback or recording.
crack on the inserted disc. � Unable to output the proper laser power
IC451 (M56788FP) IC401 (CXD2585Q)
A�
The unit stops in a recording-related operation, displaying "CHECK DISC."
� Unable to focus Stop during recording � The unit stops, being obstructed by a dirt or a crack on the disc.
d�
The unit stops in a recording related operation, displaying "CHECK DISC." The unit does not read the inserted disc, and stops.
The indication for * shows themechanism mode listed below. No.
0 1 2 3 4
Mechanism Mode
PLAY OPEN STOP � �
No.
5 6 7 8 9
Mechanism Mode
SETUP TOC READ � SEARCH REC/PAUSE
No.
A B C D E REC
Mechanism Mode
TOC REC OPC TOC CHECK PMA, ACTUAL PAUSE REC
71
|
|
|
> |
|