|
Usuarios conectados
Actualmente hay 5628 visitantes online.
|
Productos
|
Información
|
Destacado
|
|
|
|
|
No hay comentarios de productos.
1
2
3
4
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
A
1.1 GRILLE ASSY
The Grille Assy is secured to the baffle plate with two-sided tape and bosses. When removing the Grille Assy, it is necessary to wear cotton gloves.
Reasassembly
Remove the old two-sided tape attached to the rear side of the Grille Assy and the front side of the Baffle, and adhere new twosided tape. Press the bosses into the baffle plate and press the entire grille into position.
Disassembly
1. Insert the tip of your gloved finger into the gap between the Grille Assy in front and the corner of the baffle plate so that the Grille Assy is slightly lifted.
1.2 WOOFER(Disassembly)
The woofer is secured to the baffle plate with four screws from the inside. To remove the woofer, first remove the baffle plate.
Reasassembly
B
When reassembling the woofer, place it so that its + terminal is suitable for the inside. Tighten the screws to the baffle.
1.3 TWEETER(Disassembly)
2. Insert the gloved finger to the extent of the second joint into the gap between the cabinet and the Grille Assy. The tweeter is secured to the baffle plate with two screws from the inside. To remove the tweeter, first remove the baffle plate.
Reasassembly
When reassembling the tweeter, + terminal faces it aloft.
Network Assy(Caution)
C
When removing the Network Assy, pull it out a little at a time from alternate sides, because it is seated tightly.
3. Alternately and gradually lift the left and right sides of the Grill Assy by about 5 cm, sliding gloved fingers along the cabinet. When lifting the Grille Assy, be sure to lift the left and right sides alternately, but not both sides simultaneously. 1
2 1
Input terminal
Network ASSY D
Note: Be careful not to bend the Grill Assy too far. Otherwise, it may be damaged. OK : Good example NG : Bad example
Grille ASSY
Baffle Assy(Caution)
E
OK
Baffle
When reassembling the cabinet L , R and the baffle plate, secure the screws in the order shown in the figure below:
1
Grille ASSY
2
3
4
5
6
NG
Baffle
Baffle
F
2
1 2
PDP-S63
3 4
|
|
|
> |
|