PIONEER PDP-S24-LR/XIN1/E
Manual de Usuario

English
CAUTION:
÷ Attach the plasma display to the stand before installing the speakers. See the Operating Instructions packed together with the stand for how to assemble the stand. ÷ Do not place force on the speakers� front panel grille net, or stick your finger or other object into the front of the speaker, since you may damage the grille net or speaker unit itself. ÷ When using the �Air� method of mounting speakers: if the speaker angle is changed, be sure to lock the speaker before use, to prevent it from moving. If the speaker is left in the movable position, personal injury could results by pinching fingers in the gap between speaker and display. 2 Hang the speaker on the upper screw. 3 Fix the lower screw temporarily. 4 Adjust the position of the speaker and then fix the upper and lower screws firmly. 2 4

3

INSTALLATION ON THE PLASMA DISPLAY
Air mount (for adjustable-angle installation) Perform installation according to the following steps 1 to 2.

INSTALLATION ON THE PLASMA DISPLAY
Flush mount (for fixed-angle installation) Perform installation according to the following steps 1 to 2.

1 Attach the mounting fittings to the speakers.
The illustration below shows the right speaker. Attach the left side mounting fitting in the same way. 1 Attach the speaker bracket (R) to the right-side speaker. Remove the locking screw as shown.

1 Attach the mounting fittings to the speakers.
The illustration below shows the right speaker. Attach the left side mounting fitting in the same way. 1 Attach a bracket (RIGHT) to the top of the right speaker, as shown. 2 Attach another bracket (RIGHT) to the bottom of the speaker in the same way. Padding strip 1 2 * Apply the padding strip to the side of the speaker.

Locking screw

The locking screw is located in the bottom side of the speaker only. 2 Attach the top and bottom covers. The right and left lower speaker brackets are pre-applied with twosided tape to prevent the lower covers from dropping. Remove the protective paper from the tape before fixing the covers in place. Protective paper

2 Attach the speakers to the display.
The illustration below shows how to attach of the right speaker. Attach the left speaker in the same way. 1 Fix the upper screw temporarily in advance to hang the speaker on the display (In this case, leave a space of about 5 mm between the head of the screw and the display).

The display 5 mm

3

English