Note) Shield Case of Video Assy should not touch the heat sink at the primary side of Main Power Assy in standing Video Assy. (Noise may be generated and that may break the Main Power Assy)
4
Release Video Assy from PCB Hinge
1
Remove a screw
1
Remove a screw
3 3
Remove the harness from Wire Saddle VIDEO ASSY Remove the harness from Wire Saddle
2
Remove all screws and nuts from Terminal Panel
VIDEO ASSY
5
After pulling VIDEO Assy backward to release it from Terminal Panel, insert it to the PCB Hinge again.