By changing jumper-pin settings on the SENSOR-I, -J, and -K Assy's, you can use the SENSOR-I, -J, and -K Assy's one in place of another. Refer to "7.1.4 OPERATION CHECKS USING EXCHANGEABLE ASSY'S"
CN1
CN4
÷ When ordering service parts, be sure to refer to "EXPLODED VIEWS and PARTS LIST" or "PCB PARTS LIST". ÷ The > mark found on some component parts indicates the importance of the safety factor of the part. Therefore, when replacing, be sure to use parts of identical designation. ÷ : The power supply is shown with the marked box.
C
CN1 CN4
<BACK SIDE VIEW>
CN1
CN4
D
E
CN3
(BZW1513) (BZW1514)
LED-E LED-F ASSY
E F
CN2
F
CN6 CN5
D LED-D ASSY (BZW1512)
CN4 CN1
C LED-C ASSY (BZW1511)
By changing jumper-pin settings on the LED-B, and -C Assy's, you can use the LED-B Assy as the LED-C Assy, and vice versa. Refer to "7.1.4 OPERATION CHECKS USING EXCHANGEABLE ASSY'S"
