PIONEER PD-F407/RFXJ
Manual de Usuario

HOW TO LOAD THE DISCS (Be sure to read this before operation)
Loading discs into the rack
The rack is for discs No. 1 - 25 . ÷ You can load up to 25 discs in each rack. ÷ The hood cannot be opened if disc is being played. ÷ The hood cannot be opened for approximately 10 seconds after playback has finished, or during disc search. ÷ Be careful not to pinch your fingers when opening and closing the hood. ÷ Open and close the hood slowly.

Gently lift the handle to open the hood.

÷ If a disc is inserted with its label side facing to the left, it cannot be played back. Be sure to load all discs with their label sides facing to the right.

«
The rack comes out.

WARNING: Do not put your hand, or any other objects inside the rack, otherwise injury or part damage may result.

Load the disc into the rack with the label side (printed surface) facing to the right. Label side faces right
÷ By using the racks, you ÷ ÷ ÷ ÷ Do not put anything other than CDs inside the rack. Do not use adapters for 8-cm CDs. Load only one disc into each disc slot. Inserting an 8-cm CDs in between two 12-cm CDs, will make it difficult to remove the 8-cm CD. We recommend inserting 12-cm CDs starting from the right side and 8-cm CDs starting from the left side of the rack.

can load a total of 25 discs.

Gently push the handle down to close the hood.
÷ CDs cannot be played if the hood is open.

÷ The unit will not operate if the hood is open. Be sure to close the hood before attempting any operations.

To remove the discs... Open the hood when playback has stopped. Remove the disc from the rack.

÷ The hood cannot be opened if the rack is currently playing a disc, during disc search, or during the first 10 seconds after playback has finished. If you try to open the hood in one of the previous situations, �LOCK� will flash in the display. Close the hood immediately and wait for �LOCK� to go out from the display before opening the hood. Playback will stop if you open the hood for longer than 2 seconds when �LOCK� is flashing. ÷ Be sure to remove all discs from the rack, set the STANDBY/ON switch to off, wait for "OFF" to go out from the display, and unplug the power cord before moving the unit. ÷ When moving the product, be careful not to tilt it or apply strong impact to it.

8

HOW TO LOAD THE DISCS En