®
June 2000
SYSTEMS
A Creative Light & Sound Company Division of National Biological Corporation 1532 Enterprise Parkway � Twinsburg, Ohio 44087 USA 330-425-3388 � 800-321-6699 � Fax: 330-425-9700 http://www.etasys.com E-mail
[email protected]
TM
OWNER�S MANUAL OPERATION INSTRUCTIONS
ON / OFF
CIRCUIT BREAKER
PROTECTION ON
POW
PD8 CONDITIONED ER DISTRIBUTION
ETA SYSTEMS SOUND COMPANY VE LIGHT AND
A CREATI
PD8
ON / OFF PROTECTION ON
CIRCUIT BREAKER
LIGHTS HIGH
PD8L CONDITIONED TION POWER DISTRIBU
RACK ILLUMINATOR volt, incandescent lamp. 120
OFF LOW
CAUTION: Replacement lamp is a standard
ETA SYSTEMS
A
CREATIVE LIGHT AND SOUND
COMPANY
PD8L
BACK PANEL PD8/PD8L
ETA�s line of Conditioned Power Distribution units are designed to prevent electrical damage to sensitive electronic equipment from high amplitude/short duration spikes, random surges, and EMI/RFI noise, which is inherent in utility power lines. Power line sources which are not preconditioned or filtered can affect reliable operation of sensitive audio, computer, and other electronic equipment, and may cause premature failure, expensive repairs, or unanticipated replacement from nonrepairable damage. As inherent problems in utility AC power lines increase for various reasons, and the need for noise-free, conditioned power increases, ETA is there with the units to protect your valuable electronic equipment. With present demands on the power utilities, voltage spikes, power surges, electrical noise, and power failures are commonplace. This "garbage" in the power delivered can reduce the fidelity of audio systems, cause premature
failure, or result in extensive damage or destruction of electronic equipment. ETA Conditioned Power Distribution units feature a master power switch, conveniently located on the front control panel, that switches the rear panel AC outlets ON and OFF. An LED next to the master power switch indicates the power conditioning circuitry is working and the rear panel AC outlets are powered. Maximum total wattage input is 1800 watts and the 8 power output receptacles are protected with a 15amp (total unit) resettable circuit breaker. Note: The front panel LED is normally lit when the power switch is in the ON position. If the power switch is ON and the LED is not lit, power may still be present on the output AC receptacles, but the power conditioning circuitry is not working. Do not continue use of the power conditioning unit and refer trouble-shooting to a qualified electronic technician or contact ETA Customer Service for assistance.
EASY INSTALLATION The PD8 and PD8L is easily mounted into a standard 19-inch rack or placed into a free-standing position. With the PD master power switch in the OFF position, plug the line cord into a convenient AC receptacle. Place the PD8 power switch into the ON position and check that the front panel LED is lit. The lit LED indicates conditioned and filtered AC power is connected. Then, with their master power switches in the OFF position, plug the equipment to be protected into the PD's rear panel AC receptacles. Turn on the power switches of the equipment plugged into the PD8.
All designs and specifications are subject to change without notice. Copyright © 2000 ETA Systems.