EMERSON PD5500
Manual de Usuario

PD5500 O/M.QXD

7/9/01

4:35 PM

Page 5

SETTING THE CLOCK
When the unit is first plugged in, the time display will not be set. Set the time as follows:

1

2

3

Make sure the unit is OFF. Press the CLOCK SET/MEMORY button and the hours will blink.

Set the correct hour (and AM/PM) using the Tuning Up/Clock Adj.(+) FWD. ( ) and (�) REV. ( ) buttons.

When finished setting the hour, press the CLOCK SET/MEMORY button again and the minutes will blink.

4

5
NOTE: In case the main power supply is interrupted, the clock will be reset unless back-up batteries are installed.

Set the correct minute using the Tuning Up/Clock Adj.(+) FWD. ( ) and (�) REV. ( ) buttons.

When finished setting the hour, press the CLOCK SET/MEMORY button again and the clock will be set.

5